Adaptec Installation
   Revision:       06/24/94
   (make sure you downloaded latest driver in zip files)
      
   
   In order to use this procedures you need to test server.exe with 
   your motherboard.
   ================================================================

   Boot to MS-DOS 5.0, 6.0, 6.2 (no config.sys)
   run server -ns -na (do not run startup.ncf, autoexec.ncf)
   type in fileserver name
   type in internal ipx number
   type memory
     - if you see all your memory use procedure I
     - if you do not see all your memory use procedure II
	(This is due to a problem with server.exe and your motherboard)
      

      Procedure I
      ===========

      Netware 3.11, 3.12, 4.0x
      ------------------------
      STARTUP.NCF
      set auto register memory above 16 megabytes = on
      set reserved buffers below 16 meg = 40
	
      (Add 20 buffers for each additional SCSI device supported by the  
      Adaptec driver with a minimum of 200 buffers for Sbackup, Arcserve)

      i.e. load AHA1540 port=xxx          
      i.e. load AHA1640 port=xxx

      Note:
      - above16=y is not necessary anymore (154x, 1640). 
	(autodetection of memory)

	   

      Procedure II
      ============

      Netware 3.11, 3.12:
      -------------------  
      STARTUP.NCF
      set auto register memory above 16 megabytes = off
      set reserved buffers below 16 meg = 40
      (Add 20 buffers for each additional SCSI device supported by the  
      Adaptec driver with a minimum of 200,300 buffers for Sbackup, Arcserve)
			
      AUTOEXEC.NCF (must be in same path as STARTUP.NCF, C: or A:)
      file server name <servername>
      ipx internal net <address>
      register memory 1000000 ???????         (see Memory) 
      i.e. load AHA1540 port=xxx
      i.e. load AHA1640 port=xxx
      (if you have a problem with not mounting the first time, add
       command line "scan for new devices")
      mount sys
      load <landriver>.lan
      bind ...
      mount <volumes> (all)
      load nlms
      

      Netware 4.0x:
      -------------
      STARTUP.NCF
      set auto register memory above 16 megabytes = off
      set reserved buffers below 16 meg = 40
      (Add 20 buffers for each additional SCSI device supported by the  
      Adaptec driver with a minimum of 200 buffers for Sbackup, Arcserve)
      register memory 1000000 ???????         (see Memory)
      i.e. load AHA1540 port=xxx
      i.e. load AHA1640 port=xxx
      
      AUTOEXEC.NCF (can be on SYS: Volume)
      file server name <servername>
      ipx internal net <address>
      load <landriver>.lan
      bind ...
      mount <volumes> (all)
      load nlms



 Memory:
 -------       
 register memory <startadress>  <range> (both nummbers are in hex: )
 decimal 16777216/1048576/65536/4096/256/16/1
 16Meg =  1          0     0     0    0   0 0  =1'000'000

 Example:     
      24M    :register memory  1'000'000  800'000
      32M    :register memory  1'000'000  1'000'000
      48M    :register memory  1'000'000  2'000'000
      64M    :register memory  1'000'000  3'000'000